Changeover time approx 30 mins. On some, maybe all standard Photons, the existing column is not precisely machined at the ends, but is instead linished, so even if the carriage rollers are perfectly adjusted, it still may not stand vertically, particularly fore and aft.The upgrade purpose is to address these problems... Z Wobble', (Regular striping in the Z axis, often at 2mm Pitch). Existing Z Column not being exactly vertical to the Platform.
Excess Flexing/Play of whole moving carriage on vertical axis. Provided the Build plate is flat, correctly set level and firmly locked, the performance should be very consistent with no more unexplained failure of prints to adhere to the build plate, allowing the Photon to reliably reach it's full potential. For clear installation instructions, please see. Tools required:- 2.5mm, 3mm & 4mm Hexagon Wrenches (not included). Custom Anti-Backlash Nut with Uprated Spring.
Lithium Base grease for Z Rod (Leadscrew). The item "Twin Rail Z Slide Upgrade for Anycubic Photon 3D Resin DLP LCD Printer" is in sale since Thursday, June 27, 2019. This item is in the category "Computers/Tablets & Networking\3D Printers & Supplies\Parts & Accessories".The seller is "cycle_all_day" and is located in Winchester. This item can be shipped worldwide.